Replacing The Lamp; Closing The Door; Installation - Zanussi ZBA22422SA Benutzerinformation

Problem
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.

Replacing the lamp

The appliance is equipped with a
longlife LED interior light.
CAUTION!
Disconnect the plug from the mains
socket.
1. At the same time, with the fingers expand
up and down the transparent cover and
unhook it in the direction of the arrows.
1
2
1

Installation

WARNING!
Refer to Safety chapters.
Location
Refer to the assembly instructions
for the installation.
To ensure best performance, install the
appliance well away from sources of heat such
as radiators, boilers, direct sunlight etc. Make
sure that air can circulate freely around the back
of the cabinet.
www.zanussi.com
All manuals and user guides at all-guides.com
Possible cause
The food products' temperature
is too high.
Many food products are stored at
the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened often. Open the door only if necessary.
2. Replace the lamp with one of the same
3. Reassemble the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective door
Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate class
indicated on the rating plate of the appliance:
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Store less food products at the
same time.
Defrost the appliance.
power and shape, specifically designed for
household appliances. (the maximum power
is shown on the light bulb cover).
Make sure that the light comes on.
"Installation".
gaskets. Contact the Authorised Service
Centre.
Climate Ambient temperature
class
SN +10°C to + 32°C
Solution
21