Connecting Analyzer To Power Supply - Stihl ADG 1 Gebrauchsanleitung

Never bridge the contacts of the battery
analyzer with metallic objects (e.g. nails,
coins, jewellery) – short circuit. The unit
may be damaged by a short circuit.
Do not operate in a hazardous location,
i.e. in a location where there are
combustible liquids (fumes), vapors or
dusts. The unit may produce sparks,
which may ignite the dust or vapors –
risk of explosion.
In the event of smoke or fire in the unit,
disconnect it from the wall outlet
immediately.
Check the unit's connect -
ing cord regularly for
damage. If the power
supply cord is damaged,
immediately disconnect
the plug from the wall
outlet to avoid the risk of
electric shock.
Never jerk the power cord to disconnect
it from the wall outlet. To unplug, grasp
the plug, not the cord. Have a damaged
power cord repaired by a qualified
electrician.
Do not use the connecting cord for any
other purpose, e.g. for carrying or
hanging up the unit.
Check the power cord and plug for
damage before each use. Never use
damaged cords and plugs or connecting
cords that do not comply with
regulations.
Position and mark the power supply cord
so that it cannot be damaged or stepped
on, tripped over or endanger others.
ADG 1
To reduce the risk of electric shock:
Always connect the power cord to a
–
properly installed wall outlet.
Make sure the insulation of the
–
power cord and plug is in good
condition.
After using the unit, unplug it from the
wall outlet.
Remove the battery before transporting
or storing the unit.
Store out of the reach of children.
Connecting Analyzer to
Power Supply
Mains voltage and operating voltage
must be the same.
3
Insert the mains plug (1) in the wall
N
outlet (2).
The following information is displayed
(shown with gray background):
Battery analyzer
ADG 1
A self test is performed after the unit is
connected to the power supply. During
this process the light emitting diode (3)
on the unit lights up green for about 1
second, then red and goes off again.
Self test
When self test is completed:
Insert the battery.
Insert the battery in the unit – see
N
"Testing battery".
English
2
1
13