Special Safety Instructions - Power Craft 69824 Gebrauchsanweisung

CHAIN GRINDER
Symbols used
Symbols are sometimes used on the
packaging, on the machine or in the
accompanying documentation.
A key to these symbols is given below.
Protective goggles must be worn!
Use protective goggles when
operating the machine!
GB
Instruction manual
Read the instruction manual
carefully before use, and keep it for
future reference.
Power rating
Indicates the machine's maximum
power.
Voltage/frequency
Indicates the required voltage and
frequency of the power supply
to which the machine is to be
connected.
Speed
Indicates the machine's speed(s)
or speed range in revolutions per
minute.
Disc size
Gives the diameter of the disc.
26
Introduction
To get the most out of your new chain
grinder, please read through these
instructions and the attached safety
instructions before use. We also recommend
that you save the instructions in case you
need to refer to them at a later date.
Technical data
Voltage/frequency:
Power rating:
Speed:
Grinding disc:
Hole diameter:
Suitable for grinding type 325 and 404 saw
chains

Special safety instructions

The chain grinder must not be used for
grinding anything other than power saw
chains.
Always use protective goggles and ear
protectors when using the chain grinder.
Never use damaged grinding discs.
Never use grinding discs that are too large
or with a hole diameter that is too large.
Never use discs with a maximum RPM less
than that of the tool.
Never tighten the outer flange too much, as
this may damage the grinding disc.
Never put your hands into the working area
while the chain grinder is running.
230 V ~ 50 Hz
90 W
5,000 rpm
Ø104×22.2×3.2 mm
10 mm