Steinbach 012161 Bedienungsanleitung Seite 9

EN
Replace the lip seal on the skimmer cutout on. Make sure that the
flange holes fit!
From outside the pool, place the gasket and skimmer housing
against the pool wall in line with the hole.
From inside the pool, place the faceplate and gasket against the
pool wall in line with the hole. Push the screws carefully through pool
liner but do not securely tighten them until all the screws are in
place. Ensure that the housing and inside faceplate are correctly
aligned and tighten the screws into position but do not over tighten
as you may damage the screws and / or the pool wall and liner. En-
sure that the gasket is not pinched or damaged.
WARNING: Do not create multiple holes as this will void your war-
ranty and cause damage to the pool liner. Carefully trim off any pro-
truding part of the liner inside the connections after installation.
Place the basket into the skimmer housing and fix the cover . Coat
the Teflon tape to the threading of the outlet connector and then
connect it to the skimmer housing.
Clip the weir to the front of the pool skimmer housing if not already
assembled.
Make sure the skimmer is sealed to the pool wall and no water is
leaking.
Connect the filtration system to the pool. Follow the filtration sys-
tem's instructions for assembly requirements before operating.
WARNING! Never permanently install the skimmer or the inlet be-
fore the water arrives to within a few centimeters of them, because
the liner has to be properly taut with the pressure of the water.
WARNING! Cutting more liner than necessary will damage and void
the pool liner, so please trim with extra care.Caution! Do not damage
any part of the inside of the skimmer box and Inlet and outlet con-
nections with the knife.
FILLING THE POOL - STEP 2
Before you fill the pool with water, thoroughly check to see if there
are any loose screws, holes or tears in the liner. Continue to fill the
pool until water reaches half way into the skimmer box opening. The
pool is full when water reaches about 15 cm from the top of the pool
wall. (See diagram 36)
WARNING! To avoid collapse, never leave the pool without water.
POOL MAINTENANCE
Warning: If you do not adhere to the maintenance guidelines cov-
ered herein, your health might be at risk, especially that of your chil-
dren.
NOTE: The pump is used to circulate the water and to filter small
particles to keep your water clean. In order to keep you pool water
clean and hygienic you must add chemicals.
Always keep your pool clean and apply the correct pool chemicals.
Unsanitary water is a serious health hazard.
Maintain pool pH level between 77,2 to 7.6
The pH is altered by, among other factors such as water tempera-
ture, frequency of bathing, dirt and other environmental influences.
Ask your dealer's advice if you want to modify your filtration system.
Clean the PVC liner regularly with non-abrasive brushes or a venture
vacuum cleaner.
Throughout the season the water filtration system must run long
enough each day to clean the entire volume of water in the pool.
Check the filter cartridge regularly and replace dirty cartridges.
Regularly check the screws, bolts and all the metal parts for rust.
Replace if necessary.
If it rains, check that the water level is not higher than the specified
level. If water exceeds the specified levels, drain the pool to the
specified level.
Stahlwandpool Wide Sydney | 2014_V1
Cover the pool when not in use.
ATTENTION: Do not leave the drained pool outside.
ATTENTION: The use of a kit swimming pool implies the respect of
the safety instructions described in the manual of maintenance and
use.
WINTERIZATION
If you do not want to dismantle the pool in winter, please ob-
serve the following instructions:
Damage caused by freezing are not covered by warranty!
Do not drain away all of the pool water, if you do so, the pool may
collapse.
Drain the water 10 cm below the inlet valve on the pool wall. You
can use a pump or a garden hose. (See diagram 37)
Treat the pool water with a suitable chemical product.
Remove the filtration system from the pool and drain away any water
inside the filtration system.You can leave the inlets/outlets attached
to the pool. Store the filtration system in a dry place. Preferably in
the original carton.
7. Also remove any other pool accessories and store them in a dry
and cool place.
8. Protect the pool with the pool cover.
Steinbach VertriebsgmbH,
Aistingerstrasse 2, 4311 Schwertberg, Österreich
FR/IT/CZ/HU/HR/SK/SLO/RO/BG/TR: +43 (0) 7262 / 61431-0
e-mail: service@steinbach.at
www.steinbach.at
Page 9 of 50