Operating Instructions - DeVilbiss PulseDose LT Bedienungsanleitung

IMPORTANT PARTS
Specifications subject to change without notice. This chart is intended to be used only as a guide.
Cylinders vary in gaseous liter capacity by manufacturer which may result in varying use times.
Knob– This knob is used to attach the conserving device to the cylinder. (Model PD1000 only; not
1.
needed on Models PD1000U, PD1000R, or PD1000G).
• PulseDose Indicator– Either green or red light illuminates each time the unit pulses oxygen.
2.
• Normal Battery Indicator– A flashing green light indicates that there is sufficient battery power.
3. • Low Battery Indicator– A flashing red light indicates that there are 4 - 8 hours of battery life
remaining. The low battery indication time may be reduced when using NiMH batteries.
• Change Battery Indicator– A constant red light indicates that the battery should be changed
immediately. Unit can be used only in continuous flow mode until new batteries are installed.
4. Cannula Fitting– Use this fitting to attach the cannula to your PulseDose conserving device.
5. Rotary Selector– When this rotary switch is set to "OFF," the unit is not using battery power and will not
pulse. When this switch is set to one of the numbers, the unit is on and awaiting inspiration through the
nasal cannula at which time it will dose on every breath. The volume of the oxygen delivered varies
according to which prescription flow setting is chosen. The final setting on the rotary switch is "CF"; this
is the continuous flow position. In this position oxygen will flow from the cannula fitting at the default
continuous flow rate.
Oxygen Contents Gauge–Indicates the remaining pressure in the oxygen cylinder. When this gauge
6.
falls into the red section, you should switch to a new cylinder.
7. Battery Door– Use only a standard "AA" Alkaline or NiMH batteries.
8. Cylinder Connection
8a = CGA 870 Pin Index
8b = UK Bull Nose Threaded Cylinder Connection
8c = German DIN Threaded Cylinder Connection
Alerts (Model PD1000G and PD1000I)
No Inspiration Alert–If the unit is on and inspiration has not been sensed for 30 seconds (after at least one
breath has been sensed), the audible alert will activate every three seconds for one minute and then
auto shut-off.
NOTE– Continuous flow mode is not powered by the batteries and can be used regardless of the battery level.
In the event of a device failure or dead batteries, the user must manually switch the unit to continuous flow for
delivery of oxygen. The device will not automatically switch to continuous flow. The oxygen cylinder will not last
as long in continuous flow mode as it would in PulseDose mode. Unless there is a problem with the unit, such
as dead batteries, the unit should be used in PulseDose mode.
OPERATING INSRUCTIONS
Inserting A battery Into The Pulsedose Compact Conserving Device
1. Open the battery door.
2. Insert 2 "AA" Alkaline or NiMH batteries.
3. Close the battery door.
NOTE– When changing batteries, first turn the rotary selector to the "OFF" position.
Attaching Your PulseDose Conserving Device To The Cylinder
Pin Index Connections (Model PD1000 and PD1000I)
1. Loosen the knob.
EN - 6 SE-1000