Use And Operation - Klarstein 10029783 Hinweise

Plug in and switch on the cellar by pressing on the power button for a few seconds. When you use the wine
cellar for the first time (or restart the wine cellar after having it shut off for a long time), there will be a few
degrees variance between the temperature you have selected and the one indicated on the LED readout.
This is normal and it is due to the length of the activation time. Once the wine cellar is running for a few hours
everything will stabilize.
Important: If the unit is unplugged, power is lost, or turned off, wait 3 to 5 minutes before restarting the unit.
The wine cellar will not start if you attempt to restart before this time delay.
Operating Noises
To reach the desired temperature settings, Our wine cellars, like all wine cellars operating with compressors and
fans, may produce the following types of noises. These noises are normal and may occur as follows:
• Gurgling sound - caused by the refrigerant flowing through the appliance' s coils.
• Cracking/popping sounds - resulting from the contraction and expansion of the refrigerant gas to produce cold.
• Fan operating sound - to circulate the air within the wine cellar.
Loading the Wine Cellar
• You may load your wine bottles in single or double rows while taking note of the following: if you do not have
enough bottles to fill your wine cellar, it is better to distribute the load throughout the wine cellar so as to
avoid "all on top" or "all below" type loads.
• Do remove or relocate adjustable wooden shelves to accommodate larger type of bottles or increase the
capacity of the cellar by stacking the bottles up when necessary. (See removing shelves)
• Keep smalls gap between the walls and the bottles to allow air circulation. Like an underground cellar air
circulation is important to prevent mould and for a better homogeneous temperature within the cellar.
• Do not over load your wine cellar to facilitate air circulation.
• Avoid obstructing the internal fans (located inside on the back panel of the wine cellar).
• Do not slide the shelves outwards beyond the fixed position to prevent the bottles from falling.
• Do not pull out more than one loaded shelf at a time as this may cause the wine cellar to tilt forward.
• Do not cover the wooden shelves with alloy foil or other materials, as it will obstruct air circulation.
• Do not move your wine cellar while it is loaded with wines. This might distort the body of the wine cellar and
cause back injury.
13

Use and Operation