Maintenance And Modifications - Klarstein 10029783 Hinweise

3. Light Key: Each time press the key, LED light will be "ON" or "OFF", lights on the longest time for 20 minutes
at a time.
4. Lock Key: Press the key 3 seconds to remove screen lock, the screen lock will be locked which don't operation
for 5 seconds.
5. Temperature up: Each time press the key, temperature and humidity raised.
6. Temperatur down: Each time press the key, temperature and humidity down.
Defrosting
Your wine cellar is designed with "Auto-cycle" defrost system. During "Off-cycle" the refrigerated surfaces of
the wine cellar defrost automatically. Defrost water from the wine cellar storage compartment drains automa-
tically and part of it goes into a drainage container, which is located at the back of the wine cellar next to the
compressor. The heat is transferred from the compressor and evaporates any condensation that has collected
in the pan. Part of the remaining water is collected within the wine cellar for humidity purposes. This system
enables the creation of the correct humidity level inside your wine cellar required by the natural cork to main-
tain a long lasting seal.
Notes: The water collected by condensation, is therefore recycled. Under extremely dry environmental condi-
tions, you may have to add some water into the water container provided with your wine cellar.
Adjusting & removing the shelves
For easy access to the storage content, you must pull the shelves approximately 1/3 of its depth out of the rail
compartment. These wine cabinets, however, are designed with a notch on each side of the shelf tracks to
prevent bottles from falling. When removing any of these shelves out of the rail compartment, tilt the shelf as
per the diagram and simply pull out, or push in the shelf until it sits on the support brackets securely.
Common wooden shelf:
1. According to right instruction
drawing to press one side of shelf
limit pin (1), extract and remo-
ve the shelf from the other side
of support bracket (2), then take
off the shelf following the arrow
mark (3).
2. Shelf installation will be opposite
with shelf taking.
15

Maintenance and Modifications