Safety Notices; Operation - Peach Starbinder Pro PB200-30 Bedienungsanleitung

Safety notices

This machine is intended for punching
holes in sheets of paper and plastic, and
for binding these materials with a plastic
binding comb. It may only be used for
these purposes whilst observing these
instructions for use.
Always punch a test hole in a scrap piece
of paper before punching a hole into the
original.
Empty the waste receptacle
Never punch more than 12 sheets at a
time.
Description
Lever for punching and binding
1
Punching slot
2
Paper guide (orange)
3a
Paper guide (grey)
3b
Transport latch
4
Binding mechanism for opening and
5
closing the teeth of the binding comb
Waste receptacle
6
Punching slot for 4 holes
7

Operation

Setting up the machine
Place the machine on a stable surface.
Move the machine close to you so you
are able to operate it well.
Hole punching
Punch a test hole in a scrap piece of pa-
per before punching holes in the original.
Align the stack of paper by hitting the
edge on a level surface and slide it all
the way into the punching slot
The paper guide
paper guide
3a
being used as possible.
Press the hole punch lever
and down to punch holes (see Fig. A).
6
regularly.
6
.
2
is fixed. Adjust the
3b
as close to the paper size
forward
1
Binding
Insert a plastic binding comb suitable for
the thickness of the items being bound
into the binding mechanism
side up.
Push the binding lever
ward so the teeth of the binding mecha-
nism reach into the binding comb.
5
Now push the binding lever
til the teeth of the binding comb open
far enough to easily insert the paper
(see Fig. B).
Insert the punched stack of paper into the
open teeth of the binding comb. Begin
with the front cover sheet. To close the
binding comb, return the binding lever
to its original position (see Fig. C).
Remove the bound document.
4-hole punch
S lide the sheets / film into the punching
slot and push the punch lever
7
ward and down to make a 4-hole punch.
Emptying the waste receptacle
Move the binding lever
position.
Pull out the waste receptacle
empty. Reinsert the receptacle and slide
it all the way back.
Note: The transport latch
open.
Using the transport latch
Secure the lowered punch lever
transporting the machine by hooking the
transport latch
location.
open
5
slightly back-
1
back un-
1
1
to the original
1
and
6
must be
4
before
1
into the designation
4
1
for-