Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2 E
Technical data:
Valve Size:
Nominal pressure rating:
Fluid temperature range:
Face to face dimensions:
Flange dimensions:
Pre-welded flange (recommended)
Body material:
Stem, plug
seat edge:
Flow characteristics:
Plug:
Rangeability:
Leakage rate:
Max. ∆p
v100
Packing:
Valve sizes to kvs coefficients and valve stroke:
Stroke
DN
15
2.5
k
-Value
vs
4.0
Operation:
Two-way valve N.O.
Mixing valve
Caution: Pressure test of the heating installation may only be performed with opened valves.
DN 15...150
PN16 (Flanges identical to PN 10)
2°C to 140°C
DN125 and 150 Limitations as per DIN 4747 & DIN 4752
In accordance with EN 558-1 table 1 column 1
In accordance with DIN 1092-2, B Form seal strip
In accordance with DIN 1092-2
Nodular cast iron: DIN EN 1563: abbr. code: EN-GJS-400-15
Spec. No.: EN-JS1030, lacquered silver
Stainless steel Spec. -No.: 1.4305
Set into the body material
Two-way valve
Mixing valve
Guided conical brass cylinder, mat. spec. No. 2.0401
100:1
Max. 0.05% of k
DIN EN1349
300 kPa, (with valve fully open)
spring loaded Teflon/Viton/Teflon
13mm
20
25
32
6.3
10
16
E
E
L
Equal percent
Equal percent / linear
. Testing procedure with water as per
vs
25mm
40
50
65
80
25
40
63
100
The following is valid for the flow direction:
Valve plug close-off movement must always be
directed against the flow. This requirement is
fulfilled when the valve is installed as directed by
the symbols on valve body
Note:
When using a mixing valve it is recommended that
the main flow be used for flow control (due to equal
percent plug characteristic).
E = Equal percent
L = Linear
121 4612 050 E
42mm
100
125
150
160
250
350
Werbung
