Cleaning, Care And Storage - Ideen Welt P8-RM-CGG Bedienungsanleitung

3. Connect the mains plug to a suitable and easily accessible mains socket. Ensure that the power
supply is suitable. The device will now heat up and the operating light
Please Note:
Place an underlay under the device because hot glue may drip from it.
⑨
With base station
1. Tightly hold the device and place the Euro 8 socket
on the base station
2. Fold the wire stand
inserting the Euro 8 plug
3. Connect the mains plug to a suitable and easily accessible mains socket. Ensure that the power
supply is suitable. The device will now heat up and the operating light
Please Note:
⑨
Fix the base station
lifting the device.
Using for the first time
1. Push a hot glue stick
⑩
the hot glue stick
2. Allow the device to heat up for approx. 5-7 minutes. The device is then ready for use.
Gluing & switching off the device
1. Lift the device from its storage position or the base station
2. Press the trigger feed
Please Note:
When the device has heated up, it can be separated from the base station
short amount of time in order to reach inaccessible areas. As soon as the hot glue coming out of the
①
nozzle becomes viscous, the device needs to be connected to the mains supply again to reheat.
3. Apply the hot glue in small droplets. In the case of flexible materials e.g. textiles, apply the hot glue in
zigzag lines.
4. Once the hot glue has been applied, immediately push the two workpieces together for approx. 30
seconds. The area being glued will have achieved a secure bond after approx. 5 minutes at room
temperature.
5. If the hot glue stick
into the insertion opening
6. Store the device on the base station
when allowing the device to cool down.
7. Disconnect the mains plug from the mains socket after finishing your work and allow the device to
cool down for at least 30 minutes.

CLEANING, CARE AND STORAGE

ATTENTION! Never use alcohol, acetone, benzene or any
other aggressive cleaning agents to clean the plastic
components. Do not use hard brushes or metal objects.
RISK OF INJURY! Always disconnect the mains plug
from the socket and allow the device to cool down
before carrying out any work on the device.
The device is maintenance-free.
1. Make sure you have read the safety instructions before cleaning.
2. Use a slightly dampened cloth and, if necessary, a mild cleaning agent for cleaning the device.
:
⑨
.
⑥
into the forward position and place the device onto the base station
⑧
on the device into the Euro 8 socket
to the table with a screw clamp or vice so that you do not have to hold it when
⑩
into the insertion opening
is pulled completely into the device.
⑪
to regulate the flow of hot glue to your requirements.
⑩
is no longer visible in the viewing window
④
.
⑥
⑦
on the mains cable onto the Euro 8 plug
④
. Pull the trigger feed
⑨
⑨
or the wire stand
G
⑤
will be continuously lit.
⑦
on the base station.
⑤
will be continuously lit.
③
a number of times until
.
⑨
or the mains cable for a
③
, push another hot glue stick
during breaks in your work and also
⑧
⑨
by
⑩