Storage When Not In Use; Cleaning - Silvercrest SWR 1166 A1 Bedienungs- Und Sicherheitshinweise

2. WAN Settings
In Network - - -> WAN setup page , you
can change your WAN settings.
3. Wireless Signal setting
Click Signal 2.4G or 5G, you can turn off the
WiFi or adjust it's power to 1/4 or 1/2 or 3/4 of
normal power.
4. Firmware Upgrade
In Management - - -> Firmware page, you
can select a firmware and upgrade it to the router.
5. Factory Default Settings:
In Management - - -> Management page,
you can load factory default settings.
26 GB / IE
6. System Setting
In Management - - -> System Setting
page, you can set new User name and
Password.

Storage when not in use

Q
Store the product in a dry location from dusk,
protected from direct sunlight.

Cleaning

Q
Switch the product off before cleaning!
Switch the product off, remove all plugs before
cleaning!
No acid, chafing or solvent cleaning agents
should be used or the product can be
damaged.
Only clean the outside of the product using a
soft, dry cloth!
At persistent soiling, a mild cleaning agent can
be used.
It is necessary to repair the product if they have
been damaged in any way, for example, if the
housing is damaged, if liquid or objects have
penetrated the device or if the product has
been exposed to rain or moisture.
Repair work is also required if the device is
not working properly or has been dropped.
If smoke is produced, or there are any
unusual sounds or smells, turn the product off
immediately. In such cases, the product should
not be used until they have been inspected by
authorised service personnel. Only have the
device repaired by qualified personnel. Never
open the housing of the product.
Only use a clean, dry cloth for cleaning the
product and never use any corrosive liquids.
Use a slightly moistened cloth and a mild
cleaning agent to remove stubborn dirt.