Klarstein 10011354 Gebrauchsanleitung Seite 9

• Clean the inside before use.
• Fix the shelves properly according to the instruction
• In order to function at its potential, this wine cooler needs to be placed on flat floor for
approximately 2 hours before use.
• When the power is connected, cooling system starts to work. The TEMP-ADJ button is set on certain
position, which means that if the temperature in the wine cooler reaches the point set, Self-control
Temperature System stops cooling system so the temperature in the cabinet rises gradually.
• When the inside temperature rises above the set point, Cooling Self-control Temperature System
starts to work again, the cellar enters into cooling circles.
• When you want to change the temperature in the cabinet, You can press the temperature control
button, the temperature will be set. The actual temperature inside the wine cooler will be
displayed after about 3 seconds.
• You can push the "°C/°F" button to switch between Celsius and Fahrenheit and press the "Lamp"
button to control the light inside.
• This appliance is designed to be for free standing installation.
• Place your wine cooler on a floor that is strong enough to support it when it is fully loaded. To level
your wine cooler, adjust the front leveling leg at the bottom of the wine cooler.
• Locate the wine cooler away from sources of heat (stove, heater, radiator etc.). Heat sources may
increase electrical consumption. Extreme cold ambient temperatures may also cause the unit not
to perform properly.
• Avoid locating the unit in moist areas.
• Plug the wine cooler into an exclusive, proper installed-grounded wall outlet. Do not cut or
remove the third (ground) prong from the power cord under any circumstances. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an authorized
customer service center.
9
Installation Structure
Particular Precaution