Hella Gutmann mega macs 77 Schnellstartanleitung Seite 67

Measurements
Guided Measurements
• Useful dialogues for signal evaluation and troubleshooting.
• Nominal signal values for repair
8.2.1 Performing Guided Measurements
Proceed as follows to perform guided measurements:
1. Select >Measurements< in the main menu.
2. Select >Guided measurements<.
3. Select the requested fuel type.
4. Select the requested system.
5. Select the requested assembly.
6. Select the required component and or required diagnostic type from
the left selection window.
7. Select the requested parameter from the right drop-down window.
8. Regard the window with infos and instructions.
9. Confirm the window with infos and instructions with .
10. Repeat steps 8 and 9 for further window with infos and instructions
where necessary.
Measurement will be started.
Notes and instructions on the running measurement appear in the left
window. The following information can appear:
CAUTION
Mobile and Energized Parts
Risk of injury or material damage
Observe the following before starting the diagnostic work:
• Apply the parking brake.
• Protect all connected cables from heat and rotating parts.
• Regard the window with infos and instructions.
• Do not cause short circuits.
mega macs 77
EN
67