Hella Gutmann mega macs 77 Schnellstartanleitung Seite 56

mega macs 77
6.1.2 Searching and Installing a WLAN Interface
EN
Proceed as follows to connect the device to a network (router) through
WLAN:
1. Select Interfaces under > Settings in the main menu.
2. Select >WLAN<.
3. Activate the check box to be able to do the settings.
4. Observe the confirmation prompt.
5. Confirm the confirmation prompt with .
6. Open a list under IP address mode with .
7. Select >Determine automatically (DHCP)< (recommended) or
8. Create wireless network with .
9. Select the requested wireless network.
10. Regard the window with infos and instructions.
11. Confirm the window with infos and instructions with .
12. Enter the WLAN password.
13. Confirm the password with .
56
A confirmation prompt appears if Ethernet was previously activated in
the device.
If >Determine automatically (DHCP)< (recommended) is set, the
DHCP server of the network will assign an IP address to the mega
macs 77 automatically. This option is set ex works.
If >Determine manually< is selected, then enter a free network IP
address, e.g. 192.168.246.002. under mega macs IP address.
>Determine manually<.
The selection will be saved automatically.
The device searches for wireless networks.
Once the device has successfully finished searching for wireless
networks, a drop-down list of wireless networks found is then
displayed.
The input will be saved automatically.
The following message appears if the connection to the network has
been set up successfully:
Configuring the Device
Configuring the Interfaces