Installation And Connection - Oase Eco Aquarius 5500 Gebrauchsanleitung

- EN -

Installation and connection

Reassembling the unit
How to proceed:
C
Fit the flow regulator, union nut, ball joint and transition piece together and screw onto the pump outlet.
Screw the telescopic extension with the desired nozzle onto the flow regulator.
Screw the stepped hose adapter onto the flow regulator for feeding a water course if applicable.
Align the telescopic extension and hand tighten the union nut on the ball joint.
Set-up the unit
B
Attention! Dangerous electrical voltage.
Possible consequences: Death or serious injuries due to operation of this unit in a swimming pond.
Protective measures:
Do NOT use this unit in a swimming pond.
Adhere to national and regional regulations.
Note!
If the pump is used for conveying excessively soiled water, the impeller unit will be subject to increased wear
and will require earlier replacement.
Remedy:
Thoroughly clean the pond or pool before installing the pump.
Install the pump approx. 200 mm above the floor of the pond to avoid excessively soiled water from being
drawn into the pump.
Install the unit in the pond in a horizontal position on firm, sludge-free ground and ensure that it is completely cov-
ered with water.
Start-up
Attention! Risk of injury due to unexpected start-up.
The temperature monitor switches the unit off automatically in the event of overload. The unit is switched on
again automatically as soon as it has cooled down.
Possible consequences: Risk of injury due to fast rotating components.
Protective measures: Always isolate the unit (switch off and disconnect from the power supply) before
starting any work on the unit.
Sensitive electrical components.
Possible consequences: The device will be destroyed.
Protective measure: Do not connect the unit to a dimmable power supply.
This is how to connect the power supply:
Switching on: Connect the unit to the mains. The unit switches on as soon as the power connection is established.
Switching off: Disconnect the unit from the mains.
Environmental Function Control (EFC)
When started up, the pump automatically performs a pre-programmed self-test of approx. two minutes length (En-
vironmental Function Control (EFC)). The pump detects if it is running dry / blocked or submerged. The pump
switches off automatically after approx. 90 seconds if it runs dry (is blocked). In the event of a malfunction, disconnect
the power supply and flood the pump or remove the obstacle. Following this, the unit can be restarted.
12