Installation; Transport - Pony CLASSIC R Bedienungsanleitung

E N G L I S H
Capitolo 4 dfdgdhh

INSTALLATION

PACKING
The machine is packed into a cartoon.

TRANSPORT

Upon receipt of the machine packed, you are
kindly requested to immediately report to the
forwarding agent any damage suffered by the
packing during the transport.
In case of damages to the machine as well, the
insurance company of the forwarding agent will be
held responsible only if these damages have been
reported immediately.
All the installation operations must be undertaken
only by competent personnel equipped with the
necessary protection. Do not use water jets
against the machine for any reason and avoid
sudden movement or violent blows.
Do not carry the machine by hand, but only by
forklift truck or tackle.
It is advisable to move the machine complete with
the packing to where it is to be installed and then
unpack the machine.
UNPACKING AND LAYING OF
THE MACHINE
(SEE DRAWING PAGE 10-7)
Proceed as following:
a) Remove the box and verify that the machine
has not suffered
transport.
b) Sling the machine by means of two roper
(verify that are suitable for the total weight of
the machine), one at the rear and the other at
the front side of machine; then lift it by means
of forklift truck or tackle and place it where it
must be installed, without moving it by hand.
C H A P T E R 4
damages during the
Page 4-1
c) Connect accessories, if present (see next
paragraphs).
d) When installation
carefully refit all the panels, protection devices
and the accessories.
Various distances from the walls and other
equipment must be
installation of the machine in order to ensure
smooth operation and good maintenance.
The equipment does not require any fixing to the
floor.
It is recommended that the equipment should be
installed dead level
HOW TO ASSEMBLE THE
HEIGHT ADJUSTMENT FEET TO
THE TABLE
(SEE DRAWING PAGE 10-4)
The unit height can be altered manually, from
785 to 980 mm, by the relevant small feet as
following:
a) Fit the four threaded bars "POS. 42" and the
feet "POS. 43", as shown in FIG. 2. By lifting
the unit on the right you can fit the left
and on the left, you can fit the right
b) Lock the nuts so that unit is adjusted to the
required height.
HOW TO ASSEMBLE THE
SILICON MAT AND THE IRON
REST
(SEE DRAWING PAGE 10-5)
Proceed in the following way:
a) Assemble the iron rest "POS. 32" on the right
hand side of the table, through the four
available screws.
b) Position the silicon mat "POS. 33" on the iron
rest "POS. 32" through the four available
screws.
E N G L I S H
has been completed,
observed during the
foot
foot.