General; Prior To Mounting - HBM Z6AM Montageanleitung

Z6AM
1

General

HBM supplies Z6AM weighing modules for max. capacities from 50 kg to
200 kg and 500 kg. The weighing modules are designed mainly for use in
weighing applications.
These weighing modules are fitted with lateral stay rods. An integral over-load
stop is also fitted.
The modules consist of a base plate, the load cell complete with load applica-
tion elements, and the cover plate. A pendulum support is used for the load
application, providing compensation for horizontal load shifts (such as may
occur as a result of thermal strain, for example). The weighing modules are
pre-assembled and a grounding cable is supplied.
2

Prior to mounting

− Care should be taken to ensure that all surfaces for siting and mounting are
clean, smooth and level. Depending on the mounting conditions, any level-
ing error can be compensated for by using suitable wedges and compensa-
tion plates (permanently welded) or by grinding away the mounting surface,
for example. On no account must the module plates be ground.
− The base or foundation frame must be sufficiently rigid to prevent unaccept-
able deformation under load (such as sagging).
− In order to keep the mounting as free of constraining forces as possible, the
fastening holes on the foundation frame and container joint must be suitably
aligned.
− Every effort should be made to ensure uniform loading on the support
points. Care should be taken to adjust the height on the support points cor-
rectly (compensating shims need to be available). This is especially impor-
tant in the case of statically undefined supports.
A1559-2.0 de/en/fr
19
HBM