Operation; Radio Operation; Setting Up The Telescope Aerial; Setting The Time - Silvercrest SPUV 90 A1 Bedienungsanleitung

Operation

Radio operation

1. Press the button
2. Using the sound level controller VOLUME
3. Place the waveband selector switch
(FM/AM).
4. Adjust the TUNING regulator
The frequencies can be read off from the frequency scale
5. Press the button

Setting up the telescope aerial

• Remove the telescope aerial
• Extend the telescope aerial
To improve reception in the FM frequency range, slowly turn the end of the
telescope aerial
with good reception from your desired radio station, leave the telescope
a
aerial in this position. For the reception of AM transmissions, an antenna
is built into the device. For improved reception, alter the position of the device
in radio mode.

Setting the time

1. Press the button TIME
blinks.
2. Press or hold the button HOUR
3. Press or hold the button MIN
4. Press the button TIME
taken over.
o
to switch the device on.
o
to switch the device off.
a
a
in various directions. As soon as you have found a position
i
for 2 seconds. The time indicator in the display
i
once again. The programmed time will be
h
, select the desired sound level.
f
at the desired frequency range
d
to select the desired radio station.
a
from its retainer and set it up.
completely.
r
to set the hours.
t
to set the minutes.
- 10 -
s
.
j