tau D760M Installationsanleitung Seite 17

LOGIC ADJUSTMENTS
TRIMMER
second motor delay adjustment: during closing cycle from approx. 0 to 30 sec. (on top
of the time that the card calculates automatically during the SETUP procedure); during
R. ANTA
opening from approx. 0 to 6 sec (on top of the time that the card calculates automati-
cally during the SETUP procedure).
Motor 1 torque adjustment (swing 1). The trimmer is set to provide sufficient thrust
to work the gate without exceeding the limits established by current standards (EN
FR. M1
12453). Turning the trimmer clockwise (+) increases the motor torque, turning it anti-
clockwise (-) reduces it.
Motor 2 torque adjustment (swing 2). The trimmer is set to provide sufficient thrust
to work the gate without exceeding the limits established by current standards (EN
FR. M2
12453). Turning the trimmer clockwise (+) increases the motor torque, turning it anti-
clockwise (-) reduces it.
CH.AUTO Automatic closing time adjustment from 2 to 120 seconds.
turn the TRIMMER clockwise to increase adjustments; turn it anticlockwise to
Notice:
decrease.
PROGRAMMING INSTRUCTIONS (SETUP)
If a transmitter has been previously programmed, it can be used to perform the following procedure.
Otherwise, connect a Key Switch or a NO Pushbutton to the AP/CH wire terminals on the controller.
DOUBLE SWING GATE - DIP SWITCH # 4 in ON (Soft-Stop function enabled):
1 press and hold down for at least 5 seconds P1 and P2 buttons to activate the programming
mode;
2 the DL7 LED will begin blinking fast to confirm that programming mode is active;
3 press AP/CH button or the remote control: both leaves will open;
4 once opening is complete, press AP/CH button or the remote control: both leaves will stop;
5 press AP/CH button or the remote control: the leaf #2 will close at standard speed;
6 press AP/CH button or the remote control when the leaf should start to decelerate;
7 when the leaf is completely closed press AP/CH button or the remote control (leaf #2 program-
ming completed);
8 press AP/CH button or the remote control: the leaf #1 will close at standard speed;
9 press AP/CH button or the remote control when the leaf should start to decelerate;
10 when the leaf is completely closed press AP/CH button or the remote control (leaf #1 program-
ming completed);
11 the DL7 LED will stop blinking and remain steady ON (programming completed and saved).
SINGLE SWING GATE - DIP SWITCH # 4 in ON ( Soft-Stop function enabled):
1 press and hold down for at least 5 seconds P1 and P2 buttons to activate the programming
mode;
2 the DL7 LED will begin blinking fast to confirm that programming mode is active;
3 press AP/CH button or the remote control: the leaf will open;
4 once opening is complete, press AP/CH button or the remote control: the leaf will stop;
5 press 4 times AP/CH button or the remote control: the leaf will close at standard speed;
6 press AP/CH button or the remote control when the leaf should start to decelerate;
7 when the leaf is completely closed press AP/CH button or the remote control (leaf programming
completed);
8 the DL7 LED will stop blinking and remain steady ON (programming completed and saved).
GATE 2 WINGS - DIP SWITCH # 4 in OFF (Soft-Stop function disabled):
1 press and hold down for at least 5 seconds P1 and P2 buttons to activate the programming
mode;
2 the DL7 LED will begin blinking fast to confirm that programming mode is active;
D760M 17