Conrad 84 03 97 Bedienungsanleitung Seite 20

Filter installation
Press against the two top corners ("PRESS") of the front cover (4) and remove the
front cover.
Remove the pre-filter frame (6) from the front cover (4), insert the pre-filter (5) in the
front cover and replace the frame (6) on the front cover.
Now insert the combined hepa/active charcoal filter (7 and 8) in the direction of the
arrow into the ventilator housing (see notice on the frame of the charcoal filter).
Now replace the front cover (4) on the ventilator housing and press down on the two
top edges again ("PRESS").
If you want, you can also operate the device without the combined hepa/active char-
coal filter. Then the air will not be cleaned.
20
Scent function
Press on "PRESS" on the right cover and take this off.
When using a scent cartridge:
You can now insert the jasmine scent contained in the delivery into the holder by
opening the tin and putting the enclosed cover on the tin.
When using liquid scent:
You can also use liquid scent. To do so, mix the liquid scent with a bit of water and
fill up the container. However, make sure that this liquid does not spill over. Danger
of short circuit! Now slide the cover closed again.
Reinsert the cover and press "PRESS". Now the cover is closed
The scent fades after 2 to 3 days. However, this does not affect the operation of the
device. If you want, you can also operate the device without scent. Other than that,
exchange the scent cartridge or refill the liquid scent.
However, never use a scent cartridge and liquid scent together!
This may result in unpleasant scent creations.
Holder for scent cartridge
Slider for cover
Container for liquid scent
21