Herunterladen Inhalt Inhalt Diese Seite drucken

Safety Instructions; Troubleshooting - Conrad 84 03 97 Bedienungsanleitung

Luftreiniger mit ionisator
Inhaltsverzeichnis

Werbung

Safety Instructions

The guarantee is rendered invalid when damage is incurred as a
result of non-compliance with the operating instructions!
shall not be liable for any consequential damage!
We shall not accept liability for damage to property or personal
injury caused by incorrect handling or non-compliance with the
safety instructions. In such cases the guarantee is rendered invalid.
For safety and licensing reasons (CE), unauthorized conversion and/or modification
of the device is not permitted.
Always operate the device with the same voltage as indicated on the type plate on
the housing!
Pay attention when operating the device around children, disabled persons or pets!
Never allow your children to use the device for playing, especially when they try to ins-
ert items through the openings on the housing! There is risk of a fatal electric shock!
Avoid penetration of wetness or dampness into the device! Danger of electric shock!
Please pull the power plug out of the outlet when you are not going to use the device
for longer periods of time! This also applies to any cleaning work!
Never block the ventilation openings of the device with blankets or other items! Do
not place the device too close to walls or curtains!
Only use expressively recommended or provided accessories, otherwise the device
may suffer irreparable damage.
Never place the device on a metal surface or directly on a carpet!
Check both the device as well as the connection cable for damage from time to time!
Never switch the device on immediately after having taken it from a cold to a warm
environment. The condensation water that develops may destroy the device. Let the
device reach room temperature before turning it on!
Never pour out liquids above the device. There is risk of a fatal electric shock! Should
this happen, pull the power plug out of the outlet immediately and contact an expert!
Avoid any mechanical stress!
16

Troubleshooting

With this air cleaner, you have purchased a product which was manufactured accor-
We
ding to state-of-the-art. However, problems and malfunctions may occur. Therefore
we should like to explain some possibilities to you as to how you can eliminate pos-
sible faults.
However, the device may not be disassembled or repaired by a layman under any
circumstances! Only experts familiar with the pertinent regulations (VDE) may carry
out any work on the device.
Error
No power supply
No function
Weak air
output
Remote control
does not work
API does not work
Insufficient
scent output
Always observe the safety instructions here!
Possible problem
Error in the fuse box
Power plug not plugged
correctly into the power
outlet
The charcoal filter is still
wrapped
No or weak batteries in
the battery compartment
Function is not in auto mode
The filters are not correctly
installed.
The pre-filter is dirty.
The hepa/active charcoal filter
(not contained in the delivery,
order separately, order no.
840413) is dusty.
No scent in the device.
Remedy
Have the fuse
checked by an expert
Plug power plug
into the outlet again
Remove the wrapping
of the filter
Change batteries
Select auto mode
Install the filters according
to the instructions.
Clean the pre-filter.
Exchange the hepa/active
charcoal filter
(not contained in the
delivery, order separately,
order no. 840413).
Fill or refill scent.
25

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis