Sample Layouts - Petsafe PIG20-11041 Gebrauchsanweisung

• Avoid making passageways too narrow for
your pet to move about freely (e.g., along the
sides of a house).
• The Receiver Collar can be activated inside
the house if the Boundary Wire runs along
the outside wall of the house. If this occurs,
remove your pet's Receiver Collar before
bringing him inside, decrease the range using
the Boundary Width Control knob or consider
an alternative layout.

Sample Layouts

Double Loop
A Double Loop must be used when you are not establishing the Boundary Zone on all sides of your property.
When using a Double Loop, the Boundary Wire must be separated by a minimum of 1.5 m (5 ft) to avoid canceling the signal.
Remember that a Double Loop will require twice as much wire.
8
30 Twists/m
10
wists/ft
T
Sample 1:
Perimeter Loop
(Single Loop)
The Perimeter Loop
is the most common
layout. This will allow
your pet to freely and
safely roam your entire
property ( ). It can
2C
also protect pools and
landscaping ( ).
2D
www.petsafe.net
2A
C
B
A
E
Sample 2 (2E): Perimeter Loop Using Existing Fence
(Single Loop)
This layout allows you to include your existing fence as part of your
layout and keep your pet from jumping out or digging under your
existing fence. It reduces the amount of wire which will need to be
buried. From the Fence Transmitter, run the wire to
, to , to , to , twist the wires from
C C D D E E A
Transmitter. See the "Install the Boundary Wire" section for more
information on attaching the wire to a fence.
2B
D
, to
A A
back to the Fence
A
, to
B B