Vorwerk VC100 Gebrauchsanleitung Seite 46

18 Troubleshooting
Fault Possible causes and rectification
After connecting • Ensure that the mains charger with charging unit
the table vacuum
and the Tabletop vacuum cleaner are connected
to the charging unit and that the mains socket works (the function
or mains charger indicator on the handle pulsates and indicates that
solo, the charging
the Tabletop vacuum cleaner is being charged).
process does not
• Ensure that the Tabletop vacuum cleaner
begin (no pulsating
is switched off for recharging.
function indicator).
The function • The Tabletop vacuum cleaner is in safety mode;
indicator flashes this may be due to the battery being too hot.
quickly.
• Disconnect the mains charger of the Tabletop vacuum cleaner
from the mains socket and let the Tabletop vacuum cleaner
cool down.
If the problem persists, please contact
Vorwerk's customer service department.
The Tabletop vacuum The nozzle may be blocked.
cleaner does not
• Switch the Tabletop vacuum cleaner
vacuum at all or not
off and unblock the nozzle.
as good as it used
The dust chamber may not be correctly
to, and/it makes
inserted in the Tabletop vacuum cleaner.
abnormal sounds.
• Insert the dust chamber into the Tabletop
vacuum cleaner properly.
The dust chamber may be full.
• Empty the dust chamber.
Dust leaks from The dust chamber may not be correctly inserted in the device.
the device.
• Insert the dust chamber into the Tabletop
vacuum cleaner properly.
The filter unit may not have been correctly
inserted in the dust chamber.
• Insert the filter unit in the dust chamber correctly.