Waeco PerfectView CRT100 Montage- Und Bedienungsanleitung Seite 54

Assembly of the outside camera RV-22 (RV-200)
Drill a hole of Ø 13 mm nearby the camera (see G 2, illustration 9).
Debur all drill holes which are made in the sheet metal and provide with rust protection.
Provide all sharp-edged openings with a suitable bushing.
Attachment of the camera in the camera holder
Use only the screws M 4 x 8 mm for the assembly of the camera. Longer
screws damage the camera.
Insert the camera into the camera holder and align it in such a way that the objective
forms an angle of approx. 50° (see G 2, illustration 13) to the vertical axle of the
vehicle.
Fasten the camera loosely with the screws M 4 x 8 mm. The screws are tightened as
soon as the alignment of the camera has taken place by means of the monitor.
In order to minimize the corrosion of the screws, it is recommendable to grease the
tapholes.
Necessary parts for the attachment of the camera (see G 2, illustration 10 and 11).
General information on the cable laying!
Unprofessional cable-laying and cable connections cause again and again malfunctions
or damage of components.
Correct laying and connection of cables is essential for long-lasting, fault-free functioning
of retrofit components.
Please note the following points:
– Install the cable, depending on the possibility, always in the interior of the vehicle.
There it is better protected than outside the vehicle. If you, however, install the
cable outside the vehicle, pay attention that there is a safe attachment (by additional
cable clips, insulating tape etc.).
– In order to avoid damage to the cable, keep always sufficient distance to overheated
and moving vehicle parts (exhaust pipes, driving shafts, generators, ventilators etc.)
when installing cables.
– Wrap each connection at the cable (also in the vehicle) tightly with a good insulating-
tape.
Laying the cables
54