Assembly Of The Monitor - Waeco PerfectView CRT100 Montage- Und Bedienungsanleitung

Warning! Select the location of the monitor in such a way that the passengers
cannot be hurt under any circumstances (by hard-braking, traffic accident).
The monitor may not hinder the view at any time during the drive (see F 1).).
Do not assemble within the head impact range.
General installation instructions!
Please observe the following points before attaching the monitor:
– Screw monitor holder to the monitor.
– Locate the monitor with the attached holder on a trial basis.
– Consider with the selection of the location, that you have an unhindered view of the
monitor (see F 2 and F 3).
– The assembly location should be even.
– Check before the final assembly whether the necessary free space is available, also
below the assembly place chosen for the attachment of discs and nuts.
– Consider the weight of the monitor. Are reinforcements (larger washers or plates)
necessary?
– Is the installation of the connecting cable set and extension cable to the monitor
possible?
You can begin with the assembly if all points have been considered.
Pay attention when locating the monitor that this is not assembled within
the radius of an AIRBAG. Otherwise danger of injury exists when it is being
released. Do not assemble the monitor within the head-impact range.
Pay attention to a possibly large contact area between monitor holder and assembly ground.
Draw the contours of the edges of the monitor holder onto the instrument panel.
Unscrew the monitor holder from the monitor.
Hold the monitor holder within the previously drawn contours and mark at least four
different drilling points (see F 5).
When fastening with sheet-metal screws
The fastening with sheet metal screws may only be made on sheet steels with a
minimum thickness of 1.5 mm. The following is to be considered when making
drill holes into sheet metal.
– Check before whether sufficient free space for the drill outlet is present.
– In order to prevent a running of the drill, prick punch with hammer and prick punch.
– Debur all drill holes and provide with rust protection.
Drill a hole of Ø 4 mm at the points drawn beforehand.
Screw on monitor holder with the metal screws 5 x 20 mm.
Necessary parts for the attachment of the monitor holder see F 6 to F 8.

Assembly of the monitor

47