Waeco PerfectView CRT100 Montage- Und Bedienungsanleitung Seite 43

General safety and installation instructions
Warning! Parts of the back-up video system
RV- 100 or RV-200 which are fastened in the vehicle, must be fastened in such
a way that they do not detach under any circumstances (hard-braking, traffic
accident) and thus cause injuries of the passengers.
Pay attention when locating the components into the interior of the vehicle that
these are not assembled within the radius of an AIRBAG. Otherwise danger of
injury exists when it is being released. Parts of the attachable parts concealed
under panelling are to be fastened in such a way that they cannot become
loose and damage other parts and lines and impair vehicle functions (steering,
pedals etc.).
Always observe the safety information of the manufacturer! Some work (e.g. at
retaining systems such as AIRBAG etc.) may be executed only by trained
technical personnel!
Caution! To check the voltage in electrical cables, use only a diode test lamp
(see A 1) or a voltmeter (see A 2). Test lamps (see A3) which light up consume
too much current and the vehicle electronics may be damaged.
Caution! In order to avoid damages, pay attention that there is sufficient free
space for the
drill outlet (see A 4). Every drill hole must be deburred and treated with
a rust proofing agent.
Caution! When installing the electrical connections, ensure they:
1. are not sharply bent and twisted (see A 5 a)
2. do no rub at the edges (see A 5 b)
3. are not installed without protection through sharp-edged openings (see A
5c).
The camera is protected against water penetration. The sealing, however, does not
withstand a high-pressure cleaner or a sharp jet of water (see A 6).
Do not open the equipment since this impairs the tightness and the operability (see A 7).
Do not pull at the cables since this could impair the tightness and the operability of the
components (see A 8.)
The product and its components are not suitable for the operation under water (see A 9).
43