Waeco PerfectView CRT100 Montage- Und Bedienungsanleitung Seite 53

Assembly of the outside camera RV-22 (RV-200)
When fastening with sheet-metal screws
The fastening with sheet metal screws may only be made on sheet steels with a
minimum thickness of 1.5 mm.
The following is to be considered when executing drill holes in the metal plate.
– Check before whether sufficient free space for the drill outlet is present.
– In order to prevent a running of the drill, prick punch with hammer and prick punch.
– Debur all drill holes and provide with rust protection.
Drill a hole of Ø 4 mm at the points drawn beforehand.
Screw on camera holder with the metal screws 5 x 20 mm (see G 2, illustration 7).
Necessary parts for the attachment with sheet-metal screws
(see G 2, illustration 2 and 3).
When attaching thread screws
The following must be observed when drilling holes:
– Make sure that there is sufficient free space for the drill outlet.
– In order to prevent a running of the drill, prick punch with hammer and
prickpunch.
– Debur all drill holes and provide with rust protection.
– Pay attention that the nuts cannot pull themselves through the construction
when tightening (use possibly larger washers or sheet metal plates).
Drill a hole of Ø 5.5 mm at the points drawn beforehand.
Screw on camera holder with the thread screws M 5 x 20 mm, or longer thread screws
depending upon construction strength.
Necessary parts for the attachment with thread screws (see G 2, illustration 4 and 5).
Execution of the breakthrough for the connecting cable of the camera
Observe the information on the cable-laying.
Use for the feed-throughof the connecting cable, according to possibility,
existing feed-through possibilities, such as e.g. ventilation grids (pay attention
to sharp edges) If no feed-throughs are available, then a hole must be drilled
with Ø 13 mm. Check before whether sufficient free space for the drill outlet is
present.
53