Function Description Of The Camera Rv-20 (Rv-100) And Rv-22 (Rv-200) - Waeco PerfectView CRT100 Montage- Und Bedienungsanleitung

Assembly of the outside camera RV-20 (RV-100)
Caution! If the vehicle height or vehicle length which is entered in the car
documents is modified by the installation of the camera, then a new inspection
by the official bodies responsible (TÜV, DEKRA etc.) must take place. Let the
new acceptance be entered into the car documents by your appropriate road
traffic authority.
Warning! Select the location of the outside camera in such a way, or attach
it in such a secure manner, that under no circumstances (by branches brushing
against the vehicle roof) can persons be hurt when standing in the vicinity.
Since the outside camera should be attached at a height of at least 2 m to
allow a reasonable angle of view, ensure that there is a sufficiently stable
workstation.
General installation instructions!
Please observe the following points before attaching the outside camera:
– The outside camera should be installed at a height of at least 2 m to allow a
reasonable angle of view.
– The assembly place of the outside camera must offer sufficient firmness (e.g.
branches brushing against the vehicle roof can get caught in the camera).
– The camera must be attached horizontally and concentrically at the rear of the
vehicle (see G 1, illustration 5).
Caution! Absolutely use the insulating pad supplied and the insulating
coverings (see G 1, illustration 2 and 3). Thus fault currents due to bad mass
connections are prevented in the vehicle. Stripes in the image up to damages
are the consequences of fault currents.
The camera cable must be installed in such a way that you can easily reach the plug
connection between camera and connection cable when possibly removing the camera.
The disassembly is thereby substantially simplified.
The safest type of attachment is provided through screws being put through the
construction, whereby some points are to be considered:
1. Is there enough free space for the assembly behind the selected position?
2. Each breakthrough must be protected by appropriate measures against an inrush of
underground water (e.g. by inserting the screws with sealing compound and/or
washing off the external mounting brackets with sealing compound).
3. Does the construction at the attachment place offer sufficient firmness so that the
camera holder can be tightened firmly enough?
49