Velleman AM6621 Bedienungsanleitung Seite 3

PROGRAMMING THE TRANSMITTERS CODES
Important! After the unit is completely installed, you must program the transmitter code.
First make sure your transmitter's system is the same as this receiver's.
Recommended use a two buttons transmitter.
This receiver can program up to 6 different transmitter's code.
1. Use a ball pen and push the programming switch until the LED starts flashing then
release. It is on programming transmitter's mode.
2. Within 5 seconds press the button which you desire to remote control this system on
your transmitter and hold it until the LED solid on (the transmitter programmed), then
release the button.
3. To program second transmitter, within 10 seconds follow above procedure.
4. The procedure to program third, fourth, fifth and sixth transmitter is the same as
program second one.
5. Exit programming transmitter's mode : When you completed program transmitter
code, press the program switch 3 times again.
Note 1 : Within 5 seconds from first LED flashing, if you don't program your transmitter
the system will automatically exit programming transmitter's mode.
Note 2 : After programming the first transmitter codes, the system will wait for 10
seconds, that allows you to program other transmitter. If the system does not
receive other transmitter's code within 10 seconds, it will automatically exit
program mode.
Note 3 : For add on transmitter codes, follow the step 1 to 3 to add on.
Note 4 : If program codesover the receiver's capacity ; the latter codes will stay but the
former's will void automatically. (e.g. This receiver's capacity is 4 codes, you
can program code No. 5 in it, but code No. 1 will be void.)
Note 5 : During programming your transmitter code, there is only one button needed to
program. Be sure not to program the other button.