Oase Vitronic 18W Gebrauchsanleitung Seite 15

Safe operation
 Never operate the unit if either the electrical cables or the housing are defective!
 Do not carry or pull the unit by its electrical cable.
 Route cables/hoses such that they are protected from damage and do not present a tripping hazard.
 Only open the unit housing or its attendant components, when this is explicitly required in the operating instructions.
 Only carry out work on the unit that is described in this manual. If problems cannot be overcome, please contact an
authorised customer service point or, when in doubt, the manufacturer.
 Only use original spare parts and accessories for the unit.
 Never carry out technical modifications to the unit.
 Power connection cables cannot be replaced. If a cable is damaged, dispose of the respective unit or components.
 Only operate the unit if no persons are in the water.
 The unit, the connections and plugs are not water-proof and must not be routed or installed in water.
 Keep the socket and power plug dry.
Installation and connection
Prerequisite
 The unit head is removed. ( Removing the unit head)
Set-up the unit
How to proceed:
 B, C
 Install the unit at least 2 m from the edge of the pond.
 Only install the unit in the permitted positions to ensure fault-free operation.
 Allow sufficient space for carrying out maintenance work.
Connect the unit
Use hoses that are suitable for a pressure of at least 1 bar.
How to proceed:
 D
Shorten the stepped hose adapter to the diameter of the hose used if necessary.
– This reduces pressure losses.
Slip the hose clip over the hose, fit the hose onto the hose connector and secure with the hose clip.
– In the case of a stepped hose adapter with separate union nut, first push the union nut over the hose.
Connect the stepped hose adapter with seal to the casing.
– Connect the inlet and outlet.
– Hand tighten the stepped hose adapter.
Connect the unit to the flow-through filter.
Vitronic 18 W / 24 W / 36 W
The unit is suitable for connection to flow-through filters. Both outlet sockets are screwed to the inlet nozzles on the
flow-through filter. Adhere to the instructions for use of the flow-through filter.
How to proceed:
 E
Unscrew the cover cap.
Guide the outlet sockets with flat seal through both holes in the container wall of the flow-through filter.
Screw the inlet nozzle with O ring onto the outlet socket and hand tighten.
Connect the supply hose to the inlet socket. ( Establish connections)
- EN -
15