Camille Bauer SINEAX A 210 Betriebsanleitung Seite 25

No. Topmost display
Middle display
6
7
8
9
Mod-Tronic Instruments Limited Tel: 1 800 794-5883 Fax: 1 800 830-7122 www.mod-tronic.com
Undermost display
(Selection,
* = default)
/
*
/
*
/ *
/
*
Meaning
Operating mode of both digital outputs
"out.1" and "out.2"
Output switched-off
Energy pulse output
Alarm output
Alarm supervision source
Frequency
Neutral current
Apparent power interval
Reactive power interval
Active power interval
Power factor (cos ϕ)
Apparent power
Reactive power
Active power
Voltage
Line-neutral voltage
Line-to-line voltage
Average current (bimetal)
Phase current
Alarm limit for ON-state
Alarm limit for OFF-state
Hints
(mode)
Simulation via interface module is still possible
The output generates energy pulses
depending on the rate set under
The meter measurands to output may be
selected under .
10
If the alarm limit is exceeded the output
8
will be active (current flows). If the measurand
is below limit the output will be passive.
9
The source of the monitored is selected under
.
7
This selection is presented only if operating
mode is set to ALM previously
6
Line Type
1L',
'3Lu'
'
'3Lb',
'4Lb'
G G
G G
G G
G G
G G
G G
G G
G G
G
❍
G ❍
G ❍
❍
: 'A.on'= OR-operation of line-measurands
'A.off'= AND-operation of line-measurands
The maximum values of the alarm limits
depend on the possible measuring range
(fixed by hardware), converted into possible
primary values given by the selected system
configuration and transformation ratios.
.
11
'4Lu'
G
G
G
G
G
❍
❍
❍
❍
❍
❍
❍
❍
25