Description Of Controls - Ugolini M20/2 Gebrauchsanweisung

cover of the dispenser (see figure 1).
3 Extract the water tank, located in the lower part of the
dispenser and fill it with mineral or potable tap water. Reinstall
the tank taking care that the water filter is properly located into
its housing. (see figure 2)
IMPORTANT
Always use high quality potable water only.
4 Extract powder containers, remove their covers and fill
them with powders suitable for the purposes.
Replace closed containers into their housing taking care to
insert the lower pin into the corresponding hole in the frame
figure 1
figure 2
(see figure 3).
IMPORTANT
Use dried powder suitable to prepare food products only.
5 Operate the dispenser as described in the proper section
(see paragraph 5. 2 DESCRIPTION OF CONTROLS).
6 Install the front cover, the product outlets and the drip tray
by reversing the disassembly steps
IMPORTANT
In order to avoid possible contaminations of the food
products from external agents, the dispenser must
always be operated with the covers of the water tank and
of the powder containers closed and with the front cover
and the drip tray correctly installed.

5. 2 DESCRIPTION OF CONTROLS

The dispenser is equipped with a main switch, located under the
front cover. This switch allows to power ON and OFF the unit.
In addition the dispenser is equipped with a keyboard (see figure
4) and (see figure 5) whose functions are the following:
11
figure 3
figure 4