Hitachi BL 36200 Bedienungsanleitung Seite 6

English
Before
charging
While
The
charging
pilot lamp
lights or
Charging
blinks in
complete
red.
Charging
impossible
The
pilot lamp Overheat
lights in standby
green.
NOTE: The cooling fan does not rotate while the back pack power supply is charging.
● Regarding the temperature and charging time of the
back pack power supply
The temperatures and charging time will become as
shown in Table 3.
Battery
Charging voltage
Type of battery
Temperatures at which the back pack
power supply can be recharged
Charging time for battery capacity,
approx.(At 20oC)
21 Ah
NOTE
The recharging time may vary according to the ambient
temperature and power source voltage.
4. Disconnect the charger's power cord from the
receptacle.
5. Hold the charger fi rmly and pull out the adaptor of
back pack power supply.
NOTE
Be sure to pull out the adaptor of back pack power
supply from the charger after use, and then keep it.
When the back pack power supply is not in use, switch
it OFF.
CAUTION
○ If the back pack power supply are charged while it is
heated because it has been left for a long time in a
location subject to direct sunlight or because the back
pack power supply have just been used, the pilot lamp
of the charger lights up green. In such a case, fi rst let
the back pack power supply cool, then start charging.
○ When the pilot lamp fl ickers in red (at 0.2-seconds
intervals), check for and take out any foreign objects in
the charger's battery connector. If there are no foreign
objects, it is probable that the back pack power supply
or charger is malfunctioning. Take it to your authorized
Service Center.
○ Since the built-in microcomputer takes about 3
seconds to confi rm that the back pack power supply
being charged with UC36YRSL is taken out, wait for a
minimum of 3 seconds before reinserting it to continue
charging.
Indications of the pilot lamp
Lights for 0.5 seconds. Does not light for 0.5
seconds. (off for 0.5 seconds)
Blinks
Lights continuously
Lights
Lights for 0.5 seconds. Does not light for 0.5
seconds. (off for 0.5 seconds)
Blinks
Lights for 0.1 seconds. Does not light for 0.1
seconds. (off for 0.1 seconds)
Flickers
Lights continuously
Lights
Table 3
Charger
UC36YRSL
V 36 V
Li-ion
0oC – 50oC
h.
Table 2
If the adapter of back pack power supply is reinserted
within 3 seconds, the back pack power supply may not
be properly charged.
MOUNTING AND OPERATION
Pull-out direction of the output
cord from the high-capacity
power supply
Attaching the carrier
Attaching the carrier strap
Storing the switch panel
10
Connecting power supply
connectors and adapter
connectors
Examples showing how to use
the arm band
Main switch
Power switch
Charging the high-capacity
power supply
Using the power supply to power
cordless power tools
Warning lamp indications
Remaining capacity indications
Using the power supply to power
USB devices
Preventing short-circuits when
the power supply is not in use
Selecting accessories
6
Malfunction in the back pack
power supply or the charger
Back pack power supply
overheated.
Unable to charge.
(Charging will commence when
back pack power supply cools)
Action Figure Page
1 151
2 151
3 151
4 151
5 151
6 151
7 152
8 152
9 152
10 152
11 152
12 152
13 153
14 153
― 154