Technical Data Battery / Charger; Function Of The Unit; Changing The Battery (A); Emergency Stop Button (B1) - Rothenberger Romax Expander Compact Bedienungsanleitung

2.1

Technical data battery / charger

Battery, art.-no.:
Typ/ model ...................................... Lithium-Ion
Voltage ........................................... 14,4 V DC
Capacity ......................................... 2,6 Ah
Max. discharging temperature. ........ -20°C +60°C
Approx. charging time (90% full) ..... ca. 70 min
Weight ............................................ ca. 470 g
Recharge battery pack before first use!
Deep discharge protection may influence empty
battery detection of the machine!
3

Function of the Unit

3.1 Changing the battery
 Insert battery until the catch clicks into place. (LED flashes briefly = Contact made).
 To remove press the catch and take out the battery.
If the battery voltage is lower than necessary, the LED flashes red. Charge the
battery in the charger!
3.2 EMERGENCY STOP Button
If there is any danger to personnel or the machine during the expanding process, press the
EMERGENCY STOP button immediately and release the ON switch. The valve will open and
the piston will return to its initial position.
3.3 LED
The LED can indicate the following:
Flashes red: Battery is flat. The current extrusion process will be ended automatically. The ON
button will then be disabled and a new cycle can only be started once the battery has been
charged.
Lights up red: After 10.000 expanding cycles the LED lights up red after each cycle to indicate
that the next inspection is due. An internal counter keeps a record of the number of expanding
since leaving the factory.
3.4 To switch on
 Press and hold the ON button until the expanding cycle can be finished.
The motor cut out indicates the end of the expanding cycle.
3.5 Mounting expander head
 Remove battery!
The expander head guidance must be unscrewed until stop!
Only use the dedicated expander heads!
16
15418 Charger, art. no.:
Typ/ model ........................................
Battery
Input voltage .....................................
Input capacity ....................................
Input frequency .................................
Input power .......................................
Charging voltage ...............................
Max. charge current ..........................
Rated output .....................................
Number of battery cells .....................
Weight ..............................................
Pay attention to the electrical outlet
voltage! Check the label on the bottom
of the charger.
ENGLISH
UK 15012, EU 15017,
AUS 1500000230
Charger for 14,4V
Li-Ion Akku
220-240 V AC
0,8 A
50 – 60 Hz
75 W max.
7,2 - 33 V DC
1,8 A
58 W max.
6 - 20
ca. 450 g
(A)
(B1)
(B2)
(B3)
(C)