Cleaning And Maintenance - In Shape 17414 Gebrauchsanweisung

Setting before exercising
Press the MODE button to select training
parameters. You can set the training time,
distance or calorie consumption by pressing
the +/- buttons.
Press the Start button to start exercising.
Adjust the speed by pressing the +/-
buttons or 3/6/9/12/15.
When the set parameter is reached, the
treadmill automatically stops.
Training with an autoprogram
Press the Prog button to select an
GB
autoprogram from P1 to P15 (see the table
at the back of this instruction manual).
Be default, the training time is 20 minutes.
This can be adjusted from 10 to 60 minutes
using the +/- buttons.
Press the Start button to start exercising.
It is not possible to change the speed
manually during the training session,
as this is controlled by the computer's
autoprogram.
When the set time has passed, the treadmill
automatically stops.

Cleaning and maintenance

Wipe the treadmill down regularly with a
well-wrung cloth.
Unplug the treadmill. Open the motor cover
and remove any dust from the motor and
sensor.
Check the condition of the treadmill
regularly and tighten any bolts, screws and
nuts as necessary.
38
Lubrication
Unplug the treadmill and lubricate the plate
beneath it using silicone oil after every 30
hours of operation.
Allow the belt to run unloaded for 3
minutes to distribute the silicone oil.
If the belt runs unevenly
During operation, the belt may run to the
right or left if one of your legs is stronger
than the other. Always try to run in the
middle of the belt.
If the belt runs to the right, tighten the
right adjustment screw or loosen the left
adjustment screw.
If the belt runs to the left, tighten the
left adjustment screw or loosen the right
adjustment screw.
The belt must run at a speed of 2-3 km/h
while you make this adjustment.
You should only turn the screws a quarter
of a revolution at a time. Do not tighten the
screws too much, as this may damage the
treadmill.