Configuring - wtw pH 330i Bedienungsanleitung

Configuring pH 3301/3401
u u
r o •
L I I L
d :SP
Configuring
Note
You can leave the configuration menu at any time with <M>. The parameters
already changed are stored.
Procedure for configuring (factory settings appear in bold typeface):
• Switch off the measuring instrument.
• While pressing the <M> key, press <(!)>.
• Select the required Baud rate with <A> <T>.
Selection: 1200, 2400, 4800, 9600 Baud.
• Then press the <RUN/ENTER> key.
• Select the required display during the pH calibration with <A> <T>.
Selection: Buffer nominal value (/pH) or current electrode voltage (mV).
• Then press the <RUN/ENTER> key.
i.' i • Set the required calibration interval with <A> <T>.
| _ |_ ~ | Selection: 1... 7... 999 d.
• I • L . J • Then press the <RUN/ENTER> key.
_ ~ -
I I y . i I I
• Select the date and time step-by-step with <A> <•>. In between, press
t n e
<RUN/ENTER> key each time.
• When the last <RUN/ENTER> key has been pressed, the instrument
changes to the last active measuring mode.
12