Herunterladen Diese Seite drucken

Dell PowerVault 20xS Series Installationsanleitung Seite 7

Storage systems

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

         
 
This section provides the procedure for installing the enclosure services expander
module on the Dell PowerVault 20xS storage system.
!" ) 2'    .3        
To install the enclosure services expander module, perform the following steps.
NOTE: To perform the following installation and subsequent tasks, you view the
PowerVault 20xS storage system from its back panel.
1.
Turn off the storage system.
2.
Disconnect the power cable(s) from the electrical outlet and the power supply.
3.
Using a Phillips-head screwdriver, loosen the captive screw at the top of the
existing module on the left-back side of the storage system (see Figure 1-2).
4.
Grasp the handle of the existing module and pull it from the module bay.
enclosure services
(expander) module
     
Dell PowerVault 20xS Storage Systems Enclosure Services Expander Module Installation
captive screw
handle
1-5

Werbung

loading