PICO PicoScope 2000 Series Kurzanleitung Seite 11

Quick Start Guide
1.5 Installing the PicoScope software
1. Insert the Pico software disc into your CD drive. It should start automatically.
If it does not, simply go to My Computer (or This PC for Windows 8) and
run the Pico CD. Alternatively, the software can also be downloaded from
www.picotech.com/software.
2. Select the appropriate language.
3. Follow the on-screen instructions to install the PicoScope software.
4. Connect the oscilloscope to your PC using the USB cable supplied, as shown in the
connection diagram below.
Windows may automatically display a New Hardware Found notification.
5.
Follow any instructions shown. Note: If Windows asks to connect to
Windows Update, select No.
6. Select PicoScope 6 from the Windows Start menu.
7. If your oscilloscope requires a probe, connect one to channel A first. Touching
the tip of the probe should result in a small 50 Hz or 60 Hz signal showing in
the PicoScope window.
DO231-2 Copyright © 2006-2015 Pico Technology Ltd. All rights reserved.
PicoScope 2000 Series Oscilloscope
1. PicoScope PC
Oscilloscope
2. Oscilloscope
USB port
3. Pico Technology
USB cable
4. PC
5. PC USB port
11