How To Use The Ait Auto Loader Unit - Sony AIT Autoloader Unit TSL-SA300C Bedienungsanleitung

How to Use the AIT Auto Loader Unit

22
Chapter 3 Operation
1
Press the POWER switch on the rear panel.
The power turns on and the POWER indicator lights.
Self-testing starts: the BUSY indicator and the TAPE indicator should
each light briefly.
2
After the two indicators turn off, insert a magazine.
When the magazine is loaded, the following actions occur:
• After "Magazine Loading" appears, checking of the magazine starts.
• If the magazine is write-protected, the write-protect indicator (
• All cartridges are checked in order.
• As each cartridge is checked, its number blinks.
3
"Scan4 Ok" should be displayed, when all cartridge numbers display on
the LCD, a cartridge to be loaded into the AIT drive may be selected by
computer software or by the SELECT or ENTER buttons on the
machine. When a cartridge is loaded into the AIT drive, the TAPE
indicator lights.
4
Data may be read or written on the tape using computer software. While
reading or writing, the BUSY indicator lights.
Inserting the magazine
) appears.