Interconnections - Sony AIT Autoloader Unit TSL-SA300C Bedienungsanleitung

Interconnections

Up to fifteen Wide SCSI peripherals can be connected to the host computer
through the SCSI bus.
Use a regular Wide SCSI cable for connection. The drive uses a 68-pin half-
pitch connector.
Precautions
• Switch off the host computer and peripherals before connecting the Wide
SCSI cable.
• Make sure the Wide SCSI connectors are pressed tightly together.
• If the drive is the last (or only) device on the Wide SCSI bus, make sure to
connect a SCSI bus terminator to the unused SCSI connector.
• The total length of the SCSI cable(s) between the host computer and the last
device should be less than 3 meters.
• Cables and connections must conform to the SCSI-2 specifications. Under
these specifications, the following restrictions apply to bus connections.
Connections must be single-ended, and must have an impedance of 90 to
132 ohms.
Distance between adjacent devices should be at least 30 cm.
Branches in the bus are not allowed.
SCSI cable
SCSI CONNECTOR
SCSI ID
0
GND
Terminator
Interconnections
Chapter 2 Preparation
AC IN POWER
AC power
13