Telcoma T124 Installationsanweisungen Seite 39

GB
PROGRAMMING WORK and PAUSE TIMES
During programming the control unit has a self-learning capability with regard to work and pause times.
The S/S command will be activated several times during programming (item 10 of Fig. 1), alternatively the
Pp command can be used (terminal 16 if Fig. 2 or the remote control (if stored).
Important notes before programming:
A.Power the control unit and check correct operation of the control inputs through the relative LEDs (the
N.C. contact LEDs should be on).
B.Free the area of gate movement.
Programming:
STOP
A
A
STOP
B
B
STOP
1- Manually move the gate to mid-stroke.
2- Press and hold PROG to reset, and use a screwdriver to short the jump Reset (detail 9 of fig. 1).
3- Keep the Prog key pressed.
4-After three seconds led LD1 (and indicator lamp) turns on.
5) - Programming procedure activated
6) - Press the S/S button to start the self-learning process.
7A, 7B) - The motor performs a brief manoeuvre to check correct direction of rotation.
8A.9A) - If gate closing is activated presses S/S again to complete the manoeuvre.
8B, 9B) - If gate opening is activated (motor turning in the opposite direction), press PROG to correct the direction
and activate closing.
10, 11) - On reaching the limit stop, the motor stops and automatically restarts in opening.
12) - On completion of opening, the motor stops and the control unit starts to count the pause time.
13) - Once the required pause interval has elapsed, press the S/S button and the motor starts closing.
14) - On reaching the closing limit stop, the motor stops. Led LD1 switches off at the end of the programming
procedure.
Apre-calibration or check procedure can be made on the magnetic limit switches during programming.
Procedure:
- Release the motor. The gate must move freely
- Enter "pause and work time programming" and proceed through to point 5
STOP STOP STOP
LD1 LD1
A
STOP
B
LD1
13
14
STOP
LD1
39