Xoro HRS 2500 Bedienungsanleitung Seite 63

My Dish—Using DiSEqC 1.0/1.1
Press the RED or BLUE button and you can
influence the search and found the TV to
where you are either with Scan Mode, a
standard search or perform a "blind" search
(explained in detail on page 17).
Now, all search parameters are set and the scan can run. Press the OK button and the scan
begins.
All received TV and radio stations are displayed in the two lists. After the scan, the TV and
radio stations are stored in the two lists and the unit goes into the live image of the first TV
station.
3. Using more than two satellite by DiSEqC 1.0/1.1
The distribution of analogue and digital signals from the Astra and Eutelsat is using DiSEqC
™ (Digital Satellite Equipment Control, in other words: Deißäck) is possible if only one cable
to be laid to the satellite receiver. This new tax system complements the conventional
switching criteria, 14/18 Volt or 22 kHz, and removes the restrictions on maximum 4
switching states. In the simplest version of DiSEqC ™ is used between two universal LNBs
switch to. The 22 kHz switching circuit is used for the lower and upper frequency band LNB.
DiSEqC 1.0 controls up to four LNBs with the command position A / B and Option A / B.
DiSEqC 1.1 controls up to 64 LNBs, it will switch in several levels of government. For 16
LNBs, take for example four 4 / 1 DiSEqC 1.0 switch, whose outputs are then placed on the
inputs of a 4 / 1 DiSEqC 1.1 switch.
After selecting a configuration of the satellites
could look like. Also look here at the settings
for each satellite that the LNB type was
chosen correctly. Are required for receiving
digital TV, the digital setting (Universal).
After all settings are running you can start
searching. Here you have the option of the
two selected satellites scan individually or
both of them together.
BLUE Single Satellite Search
RED Both Satellite Search in one
run
YELLOW Delete all Satellite
GREEN Delete the selected Satellite
First Time Installation
HRS 2500
ENG 19