Setting/Releasing The Limiters; Basic Limiter Operations; Setting The Limiters - Panasonic AW-HE50HE Bedienungsanleitung

Setting/releasing the limiters

w Basic limiter operations
w
1
Press the [MENU] button.
Tap the button (rather than pressing it). When it is
pressed for 2 seconds, a menu will appear.
If this happens, press the [MENU] button again for
2 seconds to clear the menu.
Then start again from step
2
Press the [], [], [] or [] button for
2 seconds while holding down the [PRESET]
button.
The limiter for the upper limit, lower limit, left limit or
right limit is set (or released) using these direction
buttons, respectively.
The tally lamp will blink at this time.
When a limiter is set, it blinks once; when a limiter is
released, it blinks twice.
If any other button was operated between steps
2
, start again from step
1
.
1
and
1
.
w Setting the limiters
w
The limiter positions can be set by following the steps below.
When the position is set, the tally lamp blinks once.
1
Press one of the [CAM1] to [CAM4] buttons to
select the unit.
w p Setting the upper limit position of the movement
range
Press the [] or [] button of the wireless remote
control to turn the unit as far as the position which
will serve as the upper limit.
Next, perform the steps in "Basic limiter operations".
(Press the [MENU] button quickly and then press
the [] button for 2 seconds while holding down the
[PRESET] button.)
w p Setting the lower limit position of the movement
range
Press the [] or [] button of the wireless remote
control to turn the unit as far as the position which
will serve as the lower limit.
Next, perform the steps in "Basic limiter operations".
(Press the [MENU] button quickly and then press
the [] button for 2 seconds while holding down the
[PRESET] button.)
w p Setting the left‑most limit position of the
movement range
Press the [] or [] button of the wireless remote
control to turn the unit as far as the position which
will serve as the left‑most limit.
Next, perform the steps in "Basic limiter operations".
(Press the [MENU] button quickly and then press
the [] button for 2 seconds while holding down the
[PRESET] button.)
w p Setting the right‑most limit position of the
movement range
Press the [] or [] button of the wireless remote
control to turn the unit as far as the position which
will serve as the right‑most limit.
Next, perform the steps in "Basic limiter operations".
(Press the [MENU] button quickly and then press
the [] button for 2 seconds while holding down the
[PRESET] button.)
80 (E)