Getting Started; Battery Installation; Battery Warnings - Hama Digital Ball Bedienungsanleitung

g Operating Instruction
Thank you for purchasing the Digital Photo Ball! Take a
few minutes to read through this manual and you'll be
showing off your favorite pictures in no time! Be sure to
retain this manual for future reference.
Name of Parts
Power / Menu Button
Previous Image
Battery Lid
ON/Off Switch
USB Port

Getting Started

Using your new Photo Ball is a snap!
• Insert batteries into your Digital Photo Ball.
• Connect the Digital Photo Ball to your computer.
• Turn on the Digital Photo Ball.
• Start the PhotoViewer software.
• Copy photos from your PC onto the Photo Ball.

Battery Installation

1. Remove the battery lid.
2. Properly dispose of exhausted batteries.
3. Insert two (2) new "AAA" batteries (not included).
4. Be sure the positive (+) and negative (-) ends of the
batteries are facing the correct direction.
5. Replace the battery lid.

Battery Warnings

• Remove batteries when your Photo Ball will not be
used for a long time.
• Battery installation should be supervised by an adult.
• Do not mix old and new batteries.
• Do not mix alkaline batteries with standard
(carbon-zinc) or rechargeable batteries.
• Do not mix different brands of batteries.
• Be sure to insert batteries with correct polarity.
• Be careful not to short circuit the supply terminals.
• Do not attempt to recharge nonrechargeable
batteries.
6
Next Image
LCD Screen
Base
Operation
Connection
1. Connect to the PC via supplied USB cable
2. Insert the mini USB plug into the USB slot.
Note:
• Please note that while the Digital Photo Ball is
connected to the PC through the USB cable you will
not be able to view images on the Digital Photo Ball.
• The Digital Photo Ball do not charge the battery;
Turn On
1. Slide the "On / Off Switch" to "On" position and
2. Hold " " for 3 seconds to turns the Digital Photo Ball
on.
Viewing Photos
1. The Digital Photo Ball will enter photo viewing inter
face once been turns on;
2. For setting viewing mode, Press " " to enter Main
Menu; Press " " or " " to choose the item "Display
Mode";
3. Select "Slide Show" to enter auto slide show
mode,the interval between 2 photos was preset to 5
seconds; Select "Single Picture" to enter manual
slide show mode; Press " " to confirm the selection;
4. Go back to "photo viewing" by select "Exit" in the
main menu or do not push any button for 60 seconds
in operation interface
OFF
Display Mode
Auto OFF
Exit
Main Menu
5 Minutes
15 Minutes
30 Minutes
60 Minutes
No Auto Off
Auto Off
User can set auto turn off the Digital Photo Ball after
certain time.
1. Select "Auto Off" in main manual by press " " or " ";
Press " " to confirm the selection;
2. Select the preset timer by press " " or " ";
Press " " to confirm the selection;
Slide Show
Single Picture
Display Mode
Auto Off