Flight Control - Revell Control ACROBAT Bedienungsanleitung

3 INSERTING BATTERIES (REMOTE CONTROL)
3A Unscrew the battery compartment securing screw anticlockwise
and pull off the cover downwards.
3B Insert 4 x 1.5 V AA batteries and pay attention to the polarity,
as shown in the battery compartment.
3C Close the battery cover and secure with the screw.
4 CHARGING THE HELICOPTER
Attention: The battery must cool down for 10 to 15 minutes before
charging and after every flight. Failure to do so may result in the
battery becoming damaged. The charging process is electronically
monitored, but do not leave it unsupervised.
• Remove the battery from the model and switch off the remote
control 4A.
• Plug the USB charger into the charging jack of the remote control 4B
and switch on the remote control. Please do not use force. Alterna-
tively, the USB charger can be plugged into a USB port on
a computer or into an active USB hub. The Status LED of the USB
charger illuminates red.
• Now connect the battery to the charger 4C. The battery plug only fits in
the charger connection in one direction. Please do not use force! The red
Status LED on the charger goes out during the charging process.
• After a charge time of approximately 40 minutes, the LED begins to
illuminate again; the battery has been charged.
• After the charging process, remove the battery from the charger and
disconnect the charger from the remote control/USB port.
The helicopter can fly for 5-7 minutes after a charge time of
approx. 40 minutes.
5 START PREPARATION
The thrust controller (the left controller on the remote control) must
point down before being switched on 5A. Then briefly press the
ON/OFF button on the remote control 5B and the Power LED blinks red.
Now slide the battery into the battery compartment until the plug of
the battery engages in the jack of the model 5C.
helicopter on the ground so that its tail points toward you.
briefly apply full throttle with the thrust controller, after which the
14
Power LED on the remote control continuously illuminates red. Now the
helicopter is ready to start. After the flight, first switch off the helicop-
ter, then the remote control. Press the ON/OFF button again to switch off
the remote control. Remove the battery from the helicopter to switch it off.
The correct trimming is a basic requirement for achieving fault-free
flying from the helicopter.
6A
If the helicopter begins to auto-
matically rotate clockwise quickly
or slowly, briefly tap the anti-
clockwise counter-rotation trim
adjustment until the helicopter
no longer rotates automatically.
Do not simply actuate the trim
buttons continuously.
Note: Your helicopter is to fly forwards.
7A In order to start or gain
altitude, carefully move the
thrust control forward.
7C To fly along a left-handed
curve, carefully move the
directional controller to the left,
as long as the helicopter tail is
facing toward the pilot.
Place the
Then
The helicopter becomes slower when banking to the left, and faster when
banking to the right.
6 TRIM ADJUSTMENT OF THE CONTROL
If the helicopter
automatically rotates
clockwise...

7 FLIGHT CONTROL

6B
If the helicopter
automatically rotates
anti-clockwise ...
If the helicopter begins to auto-
matically rotate anti-clockwise
quickly or slowly, briefly tap the
clockwise counter-rotation trim
adjustment until the helicopter
no longer rotates automatically.
Do not simply actuate the trim
buttons continuously.
7B Move the thrust control back
for landing or to fly lower. Only
minimal corrections to the con-
troller are necessary to ensure
smoothing flying of the helicopter!
7D To fly along a right-handed
curve, carefully move the
directional controller to the right,
as long as the helicopter tail is
facing toward the pilot.
15