Replacing The Power Cable - Kawasaki K-EJS 800 Originalbetriebsanleitung

relevant material and working conditions.
General rules for cutting speeds for metal cutting
work must be complied with here as well.
You can generally use a higher speed with fine
saw blades whilst coarser saw blades require
lower speeds.
Position 1-2 = low stroke speed (for steel)
Position 3-4 = medium stroke speed (for steel,
soft metal, plastic)
Position 5-6 = high stroke speed (for softwood,
hardwood, soft metal, plastic)
8.4 Setting the pendulum action (Fig. 12/Item
8)
• The strength of the pendulum action of the saw
blade (12) can be adjusted using the selector
switch for pendulum action (8).
• You can adjust the cutting speed, the cutting
performance and the finish to the workpiece you
wish to saw.
Set the selector switch for pendulum action (8) to
one of the following positions:
Position 0: No pendulum action
Material: Rubber, ceramic, aluminium, steel
Please note: For fine and clean cuts, thin
materials (e.g. sheet steel) and hard materials.
Position 1: Small pendulum action
Material: Plastic, wood, aluminium
Please note: For hard materials
Position 2: Medium pendulum action
Material: Wood
Position 3: Large pendulum action
Material: Wood
Please note: For soft materials and sawing along
the grain
The best combination of speed and pendulum
action depends on the material you wish to saw.
We recommend you to make a trial cut on a
waste piece in order to check the ideal settings.
8.5 LED lamp (Fig. 13/Item 16)
The LED lamp (16) can be used in poor lighting
conditions to additionally illuminate the cutting
position. Press the switch (17) to switch on. To
switch off, press the switch (17) again.
8.6 Making cuts
• Ensure that the ON/OFF switch (3) is not
depressed. Only then should you connect the
mains plug to a suitable socket.
• Do not switch on the jigsaw until you have fitted
a saw blade.
• Use only saw blades that are in perfect condition.
Replace blunt, bent or cracked saw blades
immediately.
• Place the saw foot flat on the workpiece you
wish to saw. Switch on the jigsaw.
• Allow the saw blade to accelerate until it reaches
full speed. Then slowly move the saw blade along
the cutting line. Only exert gentle pressure on the
saw blade as you do so.
• When cutting metal, apply a suitable coolant
along the line you wish to cut.
8.7 Sawing out sections (Fig. 14)
Drill a 10 mm hole in the section you wish to saw
out. Insert the saw blade into this hole and start
to saw out the required section.
8.8 Making parallel cuts
• Mount the parallel stop and adjust as required
(see section 7.3).
• Observe the instructions in section 8.6.
• Cut as shown in Figure 15.
8.9 Making miter cuts (Fig. 16)
• Set the angle on the soleplate (see section 7.4).
• Observe the instructions in section 8.6.
• Cut as shown in Figure 16.

9. Replacing the power cable

If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
aftersales service or similarly trained personnel to
avoid danger.
21
GB