Cleaning The Electrodes - Würth ISS 45-M automatic Originalbetriebsanleitung

During the transport and maintenance of the
–
appliance the extraction opening is to be
closed with the connection socket.
WARNING
Safety equipment for preventing haz-
ards must be serviced and maintained
regularly. This means that the manufac-
turer's staff or persons trained by the
manufacturer must check the equipment
for proper functioning at least once a
year, i.e. check for leaks, filter damage,
functioning of the controlling elements,
etc.
ATTENTION
Risk of damage! Do not use detergents
containing silicone to clean.
No outside help is required for carrying out
–
basic maintenance and cleaning.
The appliance surface and the inside of the
–
container should be cleaned regularly using a
damp cloth.
DANGER
Risk due to dust hazardous to health. Al-
ways use disposal clothing and P2 or
higher breath-safe masks while carrying
out maintenance tasks (such as changing
filters).
Exchanging the flat pleated filter
 Open filter door.
 Take out the flat folded filter.
 Dispose off the used flat-folded filter in a dust-
tight bag according to the statutory provisions.
 Remove the dirt that has accumulated on the
pure air side.
 Insert new flat-folded filter.
 Close the filter door, it must lock into place.
Replacing the fleece filter bag/dust
Close the suction connection
Illustration
 Close the suction connection, see wet vacuum-
ing.
bag
Exchange the fleece filter bag
Illustration
 Release and remove the suction head.
 Pull the fleece filter bag towards the rear.
 Pull the locking slide up and seal the fleece fil-
ter bag tightly when removing it.
 Dispose of the used fleece filter bag in a dust-
tight bag according to the statutory provisions.
 Insert the new fleece filter bag.
 Insert and lock the suction head.
Replace the disposal bag
Illustration
 Release and remove the suction head.
 Put the disposal bag over.
 Pull the opening of the disposal bag out to-
ward the back over the suction support and
seal it tightly.
 Tightly seal the disposal bag with closure strips
underneath the opening.
 Remove disposal bag.
 Dispose of the disposal bag according to the
local provisions.
 Attach the new disposal bag.
 Pull disposal bag over the container.
 Insert and lock the suction head.
Replace membrane filter
Illustration
 Release and remove the suction head.
 Remove the membrane filter.
 Pull the new membrane filter over the contain-
er edge.
 Insert and lock the suction head.

Cleaning the electrodes

 Release and remove the suction head.
 Clean the electrodes with a brush.
 Insert and lock the suction head.
GB - 7 23