Replacing The Lamp - AEG SKS41240S2 Benutzerinformation

24 www.aeg.com
Problem
The compressor does not
start immediately after
pressing the , or after chang-
ing the temperature.
Water flows on the rear plate
of the refrigerator.
Water flows into the refriger-
ator.
Water flows on the floor.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead
to the desired result, call the
nearest Authorized Service
Centre.

8.2 Replacing the lamp

The appliance is equipped
with a longlife LED interior
light.
Possible cause
Food products placed in the
appliance were too warm.
This is normal, no error has
occurred.
During the automatic de-
frosting process, frost melts
on the rear plate.
The water outlet is clogged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are
stored at the same time.
The door has been opened
often.
1. At the same time, with the fingers
expand up and down the transparent
cover and unhook it in the direction
of the arrows.
Solution
Allow food products to cool
to room temperature before
storing.
The compressor starts after a
period of time.
This is correct.
Clean the water outlet.
Make sure that food prod-
ucts do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces-
sary.
CAUTION!
Disconnect the plug from
the mains socket.