Bdc2010 General Operating Instructions - Caframo BDC201 Bedienungsanleitung

BDC2010 GENERAL OPERATING INSTRUCTIONS

Make sure the stirrer is securely mounted as specified in the installation in-
structions. Ensure the mixing paddle or impeller is securely attached to the
desired position.
The stirrer is now ready for use to mix liquids and liquid/solid solutions. Ap-
propriate impeller and container specifications must be determined by the
operator, ensuring that all safety instructions are followed.
Keypad Functions
Power Button - Turns the stirrer on and off.
Multi-Function Button – Sets three parameters - speed (rpm),
countdown timer (minutes) and xRx agitation (seconds)
Increase Button - Increases the speed by one rpm or the count-
down timer by one minute or the xRx agitation by one second.
Decrease Button - Decreases the speed by one rpm or countdown
timer by one minute or the xRx agitation by one second.
Reverse – Reverses the direction that the impeller is turning. The
impeller turns clockwise by default.
Start/Pause Button – Allows the stirrer to be paused and started
again. Use this button to start the stirrer when ready.
Light Power Button - Turns the light on and off. The stirrer must be
plugged in for the light to function.
Four Digit LED Display – Displays either the speed (rpm), count-
down timer (minutes) or xRx agitation (seconds). The four decimal
points are used to indicate the following parameters. These do not
act as numeric decimal points.
â ã ä
â indicator that speed is displayed
ã indicator that time is displayed
ä indicator that cycle time is displayed
indicator that stirrer is turning counter clockwise
During set-up the indicator light is solid. When the stirrer is run-
ning, the indicator light flashes.
13
BDC2002 - BESCHREIBUNG
1
Ergonomischer Tragegriff
3
StirlightJ
5
Bedientaste - Drehzahl erhöhen
7
Bedientaste - Licht ein- und
ausschalten
9
Spannfutter
Spritzschutz
Gehäuse - Gegossene Rückseite
2
Gummidichtung
4
Bedientaste - Ein- und
Ausschalten
6
Bedientaste - Drehzahl verringern
8
LED-Anzeige mit vier Zeichen
Stabilisierungsstab 2 Zoll Ø
Gehäuse - Formgepresste
Vorderseite
54