Setting The Operating Mode - Flex CHE 18.0-EC Bedienungsanleitung

430.013_CHE 18.0-EC.book Seite 18 Mittwoch, 30. September 2015 1:12 13
Removing the accessories
WARNING!
Remove the battery before carrying out any
work on the power tool.
CAUTION!
Used cutting accessories may become hot.
Wear protective gloves!
 Pull the locking sleeve backwards (1.).
 Remove the cutting accessory (2.).
Fitting the three-jaw chuck
NOTE!
To fit a three-jaw chuck you will need the
original adapter from the FLEX accessories
range.
 Screw the three-jaw chuck onto the
adapter (1.).
 Insert the adapter (2.) and turn (3.) until it
locks.
 Check the lock by pulling on the three-
jaw chuck.
CAUTION!
With the three-jaw chuck fitted, never use
chiselling mode or hammer drill mode
The tool and three-jaw chuck could become
damaged.
18
Direction preselection
CAUTION!
Change the direction of rotation only when
the power tool is stopped.
 Move the direction preselector switch to
the required position:
– Left: counterclockwise (remove screws,
release screws)
– Right: clockwise (drill, insert screws,
tighten down screws)
– Middle: switch-on interlock
(tool change, when working on the
power tool)

Setting the operating mode

CAUTION!
Do not change the operating mode until
the power tool has come to a stop.
 Setting rotary knob to the required
operating mode:
Drilling
Hammer drilling
Setting the chisel position
!
(see below)
Chiselling
CHE 18.0 - EC